Warehouse management of Cell Phone Jammers should be in the good status

Warehouse management of Cell Phone Jammers should be in the good status.
GCF will all be divided by priority test cases, in seven batches, that Batch1-Batch7, one of the highest priority batch 1, batch 7 the lowest priority, high priority must be certified. Once the first four test cases with the highest priority by 80% recognition, GCF certification began on the terminal. Test equipment manufacturers must be in accordance with the priority level of the test cases provided to industry. GCF and the corresponding batch testing phase as shown in Table 7.1. The marketing center of Cell Phone Jammers is holding the meeting to analyze the market of Cell Phone Jammers .
Can be seen from Table 7.1, batch 1 contains the test protocol 1 packets (each packet or a test suite composed by the 100 or so test cases), most of the RF test cases, USIM UICC and Audio all the test cases. Lot 2 contains the agreement Pack 2, a small part of the RF test cases. Starting from 3 batches, mainly for protocol testing for certification. Lessons learned that, GCF conformance testing role in main is: makers is designed to quickly get to market a new model; operator aims to provide attractive and reliable service. The results show that market reactions are welcome to the consistency certification for the mobile phone business. GCF target to meet the market some of the work carried out as follows: define each terminal must accept the test, to ensure the end of the reliable, consistent behavior; to ensure that any GCF certification received through the end of these tests; guaranteed in the future can introduce more complex technologies. The market of Cell Phone Jammers should be well analyzed before sales.
Protocol Conformance Test for the verification test between phone and network signaling protocol meets the 3GPP release TS34.123 specification, the test is very detailed, including the following aspects of the idle mode operation: MAC layer signaling test, PDCP protocol testing, RRC test, MM flow test, CS domain call control test, the test session management process, PS domain mobility management process testing, supplementary services and short message service test. 3GPPTS34.123 defines about 700 TTCN test cases, the RLC layer, MAC layer and RRC layer were tested.
MMS business processes can be summarized in four cases: sending and receiving end to end process; end-to-application and application-to-end process; multipoint business processes, the process in a multimedia message, the receiving terminal or application before the specified number of address; MMS terminal interoperability with non-support, non-MMS received MMS messages to reach the end-user notification, can be E-mail, WWW and WAP browsing and access to multimedia messages. The electronic drawing of Cell Phone Jammers needs to be revised further.