Here contains all details of power supply module of cell phone jammer

The customer will find the indication light on the power adapter of cell phone jammer is on. 
Idle SDCCH number is still less than 2, then a TCH was set to SDCCH, until reduced to 4 SDCCH number to reach the threshold 24 or TCH. SDCCH traffic to reduce the idle SDCCH number to 14, to the SDCCH set back to the TCH, SDCCH number of not less than 8. This approach for the location of frequently updated data services district is very useful, it can dynamically adjust the number of SDCCH and TCH and timely solutions to the peak of the SDCCH traffic, effectively prevent congestion. The switch is unique to the mobile communication system, an important feature is also a wireless network, it can make a call from one cell to another cell, The M0TOROLA GSM system provides six switch decision algorithm. The jamming range of the four bands of cell phone jammer can be independently and separately adjusted.The light can indicate the position of cell phone jammer
Reasonable to set the switching algorithm and switching threshold can be well balanced traffic. It should be noted that the switching algorithm and the switching threshold set unreasonable, and will result in dropped calls rise This is what we should avoid in network optimization. First a brief description of the switch generated conditions. The switch is generated based on the following five conditions: rxquality (both uplink, the downlink), interference (both uplink and the downlink), rxlevel (both uplink, the downlink), distance (timing advance), the power budget, the first four conditions will result in an emergency switch power budget ( the Power budget) is caused by switching the main reason, which is calculated as follows: in six different types of switching algorithm PBGT (n) is greater than ho,-margin-cell is a basic trigger conditions. cell phone jammer is needed to be managed centrally. 
For the antenna, the higher the district may be appropriately adjusted BTS transmit power parameters: BS-TXPWR-MAX, BS-TXPWR-MIN, BS the-TXPWR-MAX-the CCH to reduce the base station transmit power to change the base station coverage, reducing the base station on the adjacent interference. To ensure that the cell edge at the mobile access success rate, to minimize the mobile station's access level (MS-TXPWR-MAX, MS-TXPWR-MIN), to reduce the pairs of neighboring cells interference. Through CQT testing, correct design values based on test results, concluded that the district set the best parameters. Adjusting the antenna height and antenna tilt angle to change the coverage of the district to reduce the frequency interference. cell phone jammer is to guarantee the fairness and impartiality of the examination.Repair of cell phone jammer should be immediately applied at this position.Here contains all details of power supply module of cell phone jammer.Micro-cellular switch in the macrocell call to switch to micro-cellular, and, as far as possible, reside in the micro-cellular, which share the macrocell traffic, which can effectively reduce the TCH congestion, and can solve some of the buildings problem of poor signal.